Drainage & Culvert Installation Services in Marshall, TX

Land Stream connects Marshall, Texas landowners with drainage & culvert installation contractors serving Marshall and nearby Texas communities like Jefferson, Longview, Carthage. Compare local pros, request free quotes, and hire with confidence.

Get free quotes

How Much Does Drainage & Culvert Installation Cost in Marshall, TX?

In Texas, a standard driveway culvert with headwalls typically runs $1,200 to $4,500 installed, while French drains average $25 to $60 per linear foot and full yard regrading starts around $3,000. Pipe material is a small share of the bill, excavation, bedding, and restoring the surface are what you are actually paying for.

Properties around Marshall deal with clay-heavy soils, cedar and mesquite regrowth, and long stretches of flat pasture broken up by creek bottoms. Texas pricing reflects that, so a national average is a poor guide for what you should actually pay here. Flash-flood rainfall means culverts are sized for short, intense events, not steady flow.

What to look for when hiring

  • Ask how the contractor sized the pipe, a good answer references the area draining to it
  • Require a stated fall or slope in the quote, not just a pipe length
  • Confirm who pulls the road or floodplain permit
  • Get surface restoration itemized separately from the pipe work
  • Ask for photos of the bedding before backfill on any buried line

Why getting multiple quotes matters

Drainage is the service where the cheapest bid most often fails. Comparing two or three local Land Pros lets you see who is pricing real grade work and who is just burying pipe.

Drainage & Culvert Installation FAQs in Marshall, TX

Common questions homeowners ask before hiring a drainage & culvert installation contractor.

Why do drainage systems fail?

Almost always grade, crushed pipe, or a silted inlet. Correct bedding, a real slope, and cleanable inlets are what separate a five-year fix from a twenty-year one.

How much does a driveway culvert cost in Marshall?

Most driveway culverts near Marshall run $1,200 to $4,500 installed, depending on pipe diameter, length, and whether headwalls or end sections are required.

What size culvert pipe do I need?

Sizing comes from the area draining to the crossing and local rainfall intensity, commonly 15 to 24 inches for a residential driveway. Your county may specify a minimum diameter.

Do I need a permit to install a culvert?

If the culvert sits in a public road ditch, almost always yes, and the county may require a specific pipe type and inspection. Work near a creek or wetland adds another layer of approval.

French drain or regrading, which do I need?

Surface water pooling after rain is usually a grading problem. Water that saturates and lingers in the soil is what a French drain solves. Many yards need a bit of both.

Drainage & Culvert Installation in nearby Texas cities

Other services in Marshall, TX